logo �1 on the Internet book 
main menu
Essay papers avaliable:   250 000

The widest database of original essays is now available due to EssaysBank.com! Thousands of high quality authentic essays are collected by our professional to make the lives of the students easier.

Hundreds of topics from various subjects of any educational level you will find anything you need at EssaysBank.com!

Submit your articles to the following
Search: in this section
Essay heading: ac circuits lab report
Essay specific features
Issue: Technology
Written by:
Date added: February 22, 2006
No of pages / words: 3 / 780
Was viewed: 0 times
Rating of current essay:
Essay content:

VOLTAGE 1. We connect the apparatus as shown in Figure 3, without making the connection between the diode and the transformer yet. 2. Connect the diode to the 12.SVolt tap on the transformer and plug the transformer in. We measure the peak voltage of the waveform with the oscilloscope and record this value below...
displayed 300 characters

Here are the options you can choose from:
  • Order plagiarism free custom written essay.
  • All essays are written from scratch by professional writers according to your instructions and delivered to your email on time. Prices start from $11.99 /page.
  • This option gives you the immediate access to all 184 988 essays.
  • You get access to all the essays and can view as many
    of them as you like for as little as $28.95/month.
  • Your research paper is written
    by certified writers
  • Your requirements and targets are
    always met
  • You are able to control the progress
    of your writing assigment
  • You get a chance to become an
    excellent student!

Measure the DC voltage with the Multimeter and record this value below. 3. Unplug the transformer and connect the diode to the 25.OVolt tap and once again measure and record the peak voltage and the dc voltage as before. The values are recorded on the Lab Report Sheet. PART III - PHASE ANGLE MEASUREMENT The resistor voltage varies directly with the current and is used to represent the current VR = R x i 1...
displayed next 300 characters

General issues of this essay:
Related essays:
Title Pages / Words Save
E3 Diodes and Transistors
When testing the transistor, an npn transistor is used. The linear relation between output current and current source is proved, and their ratio ?, which is the common-emitter current gain can also be measured...
5 / 1313
In other words Resistance is directly proportional to length. This is because the longer the copper wire the longer it takes for electrons to travel to the end, making the resistance of the wire longer...
3 / 736
ac circuits lab report
VOLTAGE 1. We connect the apparatus as shown in Figure 3, without making the connection between the diode and the transformer yet. 2. Connect the diode to the 12...
3 / 780
Diode Applications
All input voltage appears across the diode itself. Hence we conclude that when the input voltage is going through its positive half cycle, output voltage is almost the same as the input voltage and during the negative half cycle no voltage is available across the load...
2 / 516
Steel Plant EAF Electrical System
The electrode holders must withstand thermal cycling (not so much for our furnace, since our furnace should have a continuous feed) and severe mechanical loading and wear due to vibrations, torsion forces and such...
2 / 332
Use Of Oscilloscope For Engineers
if calibration output is 2 V peak to peak, for 0.5V/DIV, waveform will fit into 4 large divisions in voltage axis (Vertical). > Use variation to setup the time axis e...
2 / 519
The Half Wave Rectifier (Schematic 1) experiment showed that an output is only produced at R1 during the positive half cycles of the input sinusoid. This is due to the fact that the diode is inactivated, or "off" during the negative half cycles of the input...
1 / 229

Dance in the Vampire Bund | Twin Peaks | Mentes Criminales HDTV